| AeRoWing riggers > Order AeRoWing riggers |
MEASUREMENT FORM & ORDER
Use this form to fill in your measurements and send or fax back to us.
It is important that you check your measurements carefully! Carl Douglas Racing Shells cannot be responsible for incorrectly filled in forms. For advice, refer to how to measure your boat for AeRoWing riggers or contact us.
Fill in all the values below for each rowing place. All values in millimeters please!
|
INPUT |
||||||||
| Position | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| Side of Boat | ||||||||
| A | ||||||||
| B | ||||||||
| C1 | ||||||||
| C2 | ||||||||
| D1 | ||||||||
| D2 | ||||||||
| D3 | ||||||||
| E | ||||||||
| F | ||||||||
| G | ||||||||
| b-topstay | ||||||||
| d-topstay | ||||||||
| Sax Cutdown | ||||||||
| Sax Lip Depth | ||||||||
Please say if rigger bolt diameter is bigger than 1/4" (6.5mm). If ordering topstays only, for riggers not using AxioR, please give diameter of top stud on the pin.
 |
 |
 |
 |
| AeRoWing riggers > Order AeRoWing riggers |
All designs protected by © copyright, patent or unregistered design right. AeRoWing, Axior, Lo-Glide, Aussie Rail, AeRowFin and Hyteners are trademarks. © copyright Carl Douglas Racing Shells 1997. © All photography copyright John Shore or Carl Douglas Racing Shells – copying prohibited. All rights reserved.